C&K systems System 238 Manuel d'installation télécharger pdf (Page 8)

SYSTEM 238 Installation Manual

Command Locations 00 - 08

Command Location 00: Installer Combination

(1) (2) (3) (4) (5) (6)

012345

Default Values

Digit Position (1): First Digit of Installer Combination

Hard-coded to "0". Installer's combination will always start with 0.

Combination must have 5 digits in addition to Position (1).

Valid entries are 0 - 9.

Digit Positions (2) - (6): Remaining Digits in Combination

Command Location 01 - 08: User Arming Type and Combination

Digit Position (1): Arming Type

(1) (2) (3) (4) (5) (6)

91234E

**Default Values

01 = User #1 (Master)

02 = User #2

03 = User #3

04 = User #4

1 = Arm Only, No Closing (C) Report, No Shunting

2 = Disarm Only, No Opening (O) Report, No Shunting

3 = Arm and Disarm, No O/C Reports, No Shunting

05 = Us er # 5

0 6 = U s e r # 6

0 7 = U s e r # 7

08 = User #8 (Guest)

4 = Arm Only, with Closing Report, No Shunting

5 = Disarm Only, with Opening Report, No Shunting

6 = Arm and Disarm, with O/C Reports, No Shunting

7 = Arm Only, No Closing Report, Shunting Allowed

8 = Disarm Only, No Opening Report, Shunting Allowed

9 = Arm and Disarm, No O/C Reports, Shunting Allowed

0 = Arm Only, with Closing Report, Shunting Allowed

1 = Disarm Only, with Opening Report, Shunting Allowed

2 = Arm and Disarm, with O/C Reports, Shunting Allowed

Digit Position (2): First Digit of Arming Code

Hard-coded to User's PIN. You cannot change this number.

Digit Positions (3) - (6): Remaining Digits in Combination

Comination may have from 1 - 4 digits in addition to Position (2).

Valid entries are 0 - 9.

**Default Values are different for

each user. Refer to the SYSTEM

238 Programming Worksheet at the

end of this manual for other user

default values.

PROGRAMMING CONVERSIONS

Hexadecimal Value

Key Strokes



NOTE: Some programming locations allow variable-length data and require an

End-of-Number (EON) character. Program 4 ("E") after the last digit.

Fill remaining unused Positions with "0". The EON character is not required

if the last digit is in Position (6).

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

C&K systems System 238 Manuel d'installation Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité C&K systems System 238