C&K systems ST800L+ Manuel d'installation télécharger pdf (Page 10)

CIRCUIT PROGRAMMING 4 (Range 2-7)

Circuits 2 - 7 can be reprogrammed to suit your requirements. Circuit 1 is

fixed as a Final exit circuit. Circuit 8 has limited options.

ENTER PROGRAM ZONE ENTER PROGRAM ZONE

4 - 2 2 4 - 6 6

4 - 3 3 4 - 7 7

4 - 4 4 4 - 8 8

4 - 5 5

Select the circuit you wish to alter, it may then be programmed by entering one

key from the following table.

N/S = Night Set

Option no. Zones 2-7 Zone 8

1 Alarm Alarm

2 Alarm with walk through Fire

3 Alarm & Isolate in Night Set PA

4 Alarm, Walk through & Isolate in N/S Keyswitch

5 Alarm, Walk through & N/S Entry

6 Fire

7 Entry Route

8 P.A

SEE GLOSSARY OF TERMS (p.11) FOR DESCRIPTIONS OF ZONE TYPES etc.

To program zone 3 as an “Entry Route” enter - 4 3 7 *

To program zone 8 as a “Keyswitch” enter - 4 8 4 *

Momentary keyswitch Turn and hold for 0.5 sec = FULL SET

Turn and hold for 2.3 sec = PART SET

EXTENDED PROGRAMMING OPTIONS 7 (Range 1-8)

Enter 7 - 1 Disables sounder & strobe in night set.

Enter 7 - 2 Keypress tamper alarm (after 16 incorrect keypresses)

Enter 7 - 3 Full set door sense setting.

Enter 7 - 4 Convert L+ to ID- output.

Enter 7 - 5 Allow Manual Isolation of Zone 1 (Entry/Exit) In Night Set.

Enter 7 - 6 Remote Keypad PA Enable (Operated by * & # ).

Enter 7 - 7 L+ signals first to alarm.

Enter 7 - 8 Inhibit strobe in Night and Home Set and testing. (For

speech dialler connection)

HOME SET ZONE SELECTION 8 (Range 1-8 N/A if Fire or PA)

The Home Set feature enables parts of the premises to be alarm protected

while other parts are occupied. This is similar to Night Set except that an

Exit/Entry route is not required as part of the Setting or Unsetting procedure.

In programming mode press 8 to select Home Set zone selection mode, then

by pressing the keys 1-8 on the keypad you will select which zones you want

ISOLATED during home set. As a key is pressed, its relevant LED on the

display will toggle on or off. Any LED’s that are ON will be ISOLATED during

home set and any that are off will remain ACTIVE.

CIRCUIT

PROGRAMMING

ZONE

SELECTIONS

EXTENDED

PROGRAMMING

HOME SET

ZONE

SELECTION

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

C&K systems ST800L+ Manuel d'installation Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité C&K systems ST800L+