C&K systems LED Keypad Instructions d'exploitation télécharger pdf (Page 24)

User 1 can use his Master PIN to change the PINs of Users 1 - 8.

CHANGING A SYSTEM 238 AND 238i USER PIN

MASTER PIN

REQUIRED

If the new PIN is accepted, the keypad will beep twice. If you make a mistake while

programming, or if the system rejects the new PIN, the keypad will beep five times.

Enter the new PIN again and

push the # key.

The new PIN can be from two to five digits long, but must start with

the same first digit as the old PIN.

Enter the new PIN and push

the # key.

The READY, ARMED and SERVICE lights will

flash slowly to indicate programming mode.

Enter your Master PIN, push the

key, enter the digit "0", then

push the # key.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 43 44

Pas de commentaire

C&K systems LED Keypad Instructions d'exploitation Page 24